每次煮完菜后，先让吸油烟机持续工作30秒-1分钟，将残留在空气中的油烟水气及未焚烧彻底的一氧化碳抽出屋外。

同时，趁着吸油烟机上还有余热，用抹布将表面简单擦拭一遍，就能够轻松擦去沾在吸油烟机上的油污，常保洁净不油腻。

2、石家庄油烟机清洗方法

1、洗洁精、食醋浸泡法。将扇叶拆下，浸泡在用2毫升洗洁精和50ml食醋混合的一盆热水中，浸泡约15分钟后，再用洁净的抹布擦拭。油烟机的机身也用此溶液清洗，要注意将溶液温度保持在60℃左右，去污效果才是*的。

2、高压锅蒸汽冲洗法。高压锅内放半锅冷水，烧沸，待有蒸汽不断排出时取下限压阀，翻开抽油烟机将蒸汽水柱对准旋转着的扇叶，因为高热水蒸汽不断冲淋扇叶，油污水就会循着排油槽流入废油盒里。

3、将刷洗好的抽油烟机扇叶晒干后，涂上一层办共用胶水，几个月后将电扇叶上的油污成片撕下来，油污全沾在胶水层上，既便利又洁净。

4、先在灶台上铺报纸，翻开抽油烟机的开关“预热”扇叶两分钟，往抽油烟机的电扇上喷洗洁精，关掉油烟机，静置三分钟，再将60℃的热水喷入油烟机的电扇内，再翻开开关，让已溶解的油污滴到储油盒中。

标签：www.youyanjiqingxi.net

After each cooking, let the hoodsucker work continuously for 30 seconds to 1 minute, and take out the remaining fume, water and carbon monoxide in the air. At the same time, taking advantage of the residual heat on the hood, simply wipe the surface with a rag, which can easily wipe off the grease stains on the hood and keep it clean and not greasy. 2. Cleaning method of fan blade of oil-smoke suction machine 1. Cleaning detergent and vinegar soaking method. Remove the fan blades and soak them in a pot of hot water mixed with 2ml detergent and 50ml vinegar. After soaking for about 15 minutes, wipe them with a clean cloth. The fuselage of the lampblack machine is also cleaned with this solution. Attention should be paid to keeping the temperature of the solution at about 60 C. The decontamination effect is * 2. Steam washing method of high pressure pot. The pressure cooker is filled with half pot of cold water and boiled. When the steam is continuously discharged, the lower pressure limiting valve is removed. The hood is turned over and the steam column is pointed at the rotating fan blade. Because the high hot water steam continuously washes the fan blade, the oil and sewage will flow into the waste oil tank along the drainage tank. 3. After drying the fan blades of the scrubbed lampblack machine, apply a layer of common glue on them. After several months, tear off the oil stains on the fan blades. The oil stains are all on the glue layer, which is convenient and clean. 4. Spread newspapers on the kitchen table, turn on the switch of the hood and "preheat" the fan blades for two minutes, spray detergent on the fan of the hood, turn off the hood, stand for three minutes, then spray hot water at 60 C into the fan of the hood, turn on the switch, and let the dissolved oil drip into the oil storage box.